READ ALL WARNINGS AND ALL INSTRUCTIONS BEFORE STARTING. The addition of catalyst to resin starts a chemical reaction, creating heat which cures (hardens) the resin. For best results, measure resin into a graduated unwaxed cup and add the appropriate amount of catalyst (see chart below). DO NOT add excessive catalyst, as castings may fracture. MIX THOROUGHLY for approximately 60 seconds, scraping sides and bottom of mixing container. Pour into mold and allow to harden completely before removing from mold. Curing (hardening) time is dependent upon amount of catalyst used, thickness of the casting, room temperature and resin temperature, humidity and amount of colorants used. DO NOT RETURN CATALYZED RESIN TO THE CAN. KEEP CAN TIGHTLY CAPPED WHEN NOT IN USE.

Embedding objects in plastic resin involves making a casting of 2 or more layers with embedment's sandwiched between the layers. Generally, you work in reverse when embedding objects. The first layer you pour becomes the top or face of your casting. Pour first layer of catalyzed resin into mold. Allow to gel until firm enough to support the embedment's (20-30 minutes). Catalyze second batch of resin and stir. To avoid trapping air, dip embedment's into the catalyzed resin; set in place face down on the first gelled layer. Pour balance of catalyzed resin over embedment's If embedment's are not yet covered or if you want a colored background, pour a third clear or colored layer after the second layer has gelled. Embedment's can be placed in several levels to create a "floating" appearance. After final layer has been poured, allow casting to harden completely before removing from the mold.

DEVELOPED FOR USE WITH CASTIN'CRAFT'S RESIN MOLDS *. PROPORTIONS ARE BASED ON ROOM AND RESIN TEMPERATURE OF 70 DEGREES F.

*3-dimensional molds will vary greatly in amount of catalyst required depending on total volume being poured and depth of pour. Refer to mold manufacturer's instructions for proper catalyzing.